Maker Lounge Podcast

This is the third of three episodes with Trey, Rod, and Pete. Thanks for hanging out with us in the lounge. I hope you have enjoyed the first couple of episodes. If you haven’t had a chance to listen to those previous episodes, I’d suggest checking them out so you can get to know these guys a little bit more. This will be a shorter episode than the first two as we wrap up our discussion. In this s...

I’m joined today in the lounge by Pete, Trey, and Rod. Last week we talked a lot about CNCs and Lasers, and I introduced a game we’ll play again in this episode called “Yes or No.” Thanks for hanging out with us in the lounge. I hope you enjoyed the premier episode last week with these guys. Initially I was going to break this up into two parts, but there was so much to take away from this convers...

In this first episode, we talk about CNCs, lasers, and what a flathead screwdriver is. We talk about the progression of our CNC purchases and talk about some of the pros and cons of each of our setups. Pete asks some great questions about lasers and we try to convince him to get in the laser game for his shop projects. We also play a game called "Yes or No" where I give the guys a series...

What is the Maker Lounge Podcast? What's it all about? Here's a quick intro to tell you what to expect in the podcast. Make sure to tune in for our first episode. We will have Dave with 3D DIY Dave, Trey with Handcrafted By Trey, and Rod with Mountain Makers. I'm Matt with Voeltner Woodworking, and each week we will have a new cast of characters. We will break the episodes down by t...